40 extractor and shot another 100 rounds of WWB. So I reinstalled the gen 4 ejector in conjunction with the LW. However when I installed the X300 I was getting stovepipes just like my experience before. Ejection pattern was about the same as original extractor and the gen 4 ejector which was 4-5 O'Clock and several feet behind me. I replaced the upgraded ejector with the original ejector and shot 100 rounds of WWB with my X300 not installed. 40 extractor last week and did some testing today. If anyone would like further information, I'll see what I can do.Īnother update on my SSZ *** G19 that exhibited brass to face ejection problems in stock configuration. I'd love to also try Apex Tactical's extractor when it becomes available. I'm going to try to buy the new Gen4 ejector and see if that fixes the ejection problems I have. I've since cleaned the G19 when I returned from the range, but noticed the brass smear on the inside of the ejection port. The slide not locking to the rear on the last shot also occurred regularly and when I modified my grip I didn't experience that problem anymore. A lot of cases had weak ejection and a majority of the brass was at my feet, with several landing on my forearms. I also had a stovepipe at about round 150 that was the last round in the magazine. After I shot all of the WWB I brought I had 33 tallys. When I shot my first full magazine of WWB I went to my car and pulled out a notebook and a pen and began writing tally marks on how many times brass hit me in the face. Then I shot 300 rounds of 115 gr WWB and am very discouraged with my Glock. The ejection pattern seemed random but I had no brass to the face. I first shot approximately 30 rounds of 115 gr Federal with the slide not locking to the rear, which I believe is the result of an improper grip. My stock G19 purchased new with SSZ *** serial number has ejection issues. has pics of a Gen2 G17 that was pelting him with emptys.Note Randy's fix. Also, some people have had moderate round count guns with P-prefix and R-prefix guns which have functioned fine.Ĭheck in the glock extraction issue thread towards the bottom of the page, Pg 37, Member by the name of Ed L. I've seen numerous posts here about pre P prefix guns performing flawlessly which doesn't surprise me at all.
On another note, I'd like to see if anyone here has had problems with Gen3 Glocks with prefix before P**.
I'm going to keep shooting this gun and see what happens. As far as I could tell, they didn't do crap. Still kind of weak ejection, but that's sort of to be expected in a Glock. I've only put 100 rounds back through it with no real problems so far. Sent the gun back to Glock and got it back in about 2 weeks. I put about 1000 rounds through my PEY prefix RTF2 gun before the stovepipes and brass to face started to occur.
0 kommentar(er)
